Cleaning Your Cookware
Before First Use
Hand wash each piece of your new Saladmaster cooking system, including the handles, in warm, soapy water. Add one cup of vinegar per gallon of water. This removes all traces of any residual manufacturing oils, polishing compounds and any shipping debris. Rinse in clear, warm water and dry thoroughly with a clean, soft towel.
After every use, remove handles and wash both the cookware and handles in warm, soapy water. Rinse and dry. You may also remove the handles and clean your cookware in the dishwasher. Use only non-abrasive cleaner on the handles and avoid cleaning handles in the dishwasher.
For Stubborn Stains or Stuck-On Food
Rinse cookware with warm water and a mild stainless steel cleaner, such as Saladmaster Surface Master. Create a paste with the cleaner and a small amount of water, then rub the paste in a circular motion using a damp paper towel. Rinse well in warm, soapy water to remove any remaining cleaner, and then dry using a clean, dry towel.
IMPORTANT! Only use hot, soapy water on covers and exterior surfaces. Avoid use of steel wool and abrasive cleaners on the outside of your cookware or on top of the covers, as this may scratch and dull the finish.
The Saladmaster Cooking Method
Using your new Saladmaster is as easy as 1-2-3.
1. Use the correct sized pan and fill it, at least two-thirds full with food.
2. Preheat the pan on medium heat prior to use when cooking dense foods like meat or poultry. , or start with a cold, dry pan for fruits and vegetables.
Preheating usually takes three to five minutes. To tell when a pan is properly preheated, splash a few drops of water on the surface. When the water drops skitter on the surface, the pan is ready to use.
For fruits and vegetables, it's not necessary to preheat the pan.
3. Begin cooking by placing ingredients into the pan and cover with a lid over a medium heat setting on your cooktop. Listen for the sound of the Vapo-Valve™. When the valve clicks, reduce the temperature to a low setting. Cook according to recipe instructions or desired doneness.
The Saladmaster Vapo-Valve™
When the Vapo-Valve clicks, it's time to turn the temperature to a low setting. On an electric range, that will be the lowest setting. On a gas range, set to the lowest flame without the flame going out or turning off. If the lowest flame is still too high, use a heat-diffusing ring or pad made for gas ranges.
Once the vapour seal has formed around the lid and you've lowered the temperature, avoid opening the lid until the food is cooked. Peek if you must, but after replacing the lid, spin the lid slightly so the Vapo-Valve clicks; this indicates it has resealed itself. If it does not, increase the heat slightly, until the valve clicks, then reduce the heat to low.
Cooking Temperatures & Your Cookware
Be cautious when cooking on high heat, as excessive heat can cause warping. Also, when the cooking temperature is too high, your food is more likely to stick, scorch or burn. High heat can cause food to shrink and become dry, which can cause a reduction in nutritional value.
It's okay to bring large amounts of liquid to a boil in Saladmaster cookware, such as water for pasta, over medium to high heat. Once the boiling point is reached, reduce the heat to a lower temperature setting. Keep in mind that it's never necessary to set a burner on the highest heat, even when boiling water. Lower heat after boiling point has been reached.
Avoid rapid changes in temperature, such as placing a hot pan in cold water. This can cause stainless steel to warp. Be sure to let your cookware cool first, then add warm water. Never put cold water into a hot pan.
Refrain from placing salt directly on the interior surface of your cookware. When using salt, make sure it dissolves completely to avoid leaving white spots. Salt can cause pitted surfaces.